Millibareinstellung bei Höhenmessern

Drawing 1

• Remove rotary knob
• Hole nut ca. 5 mm untwist with special turnscrew
• Mount rotary knob again
• Raise the rotary knob, simultaneous turn respective adjust the sub-scale
• Rotary knob snap in to bottom, hole nut tight again (Attention: adjusting of the torque

Drawing 2

• Take out special screw
• Lift up knob and turn the sub-scale
• Engage the knob back and take in the special screw (Attention: adjusting of the torque)
• Important! Seal up the special screw